looking for a speedometer cable for a 1962 cutlass

Old Apr 4, 2018 | 05:03 AM
  #1  
HP62's Avatar
Thread Starter
Registered User
 
Joined: Jan 2013
Posts: 9
looking for a speedometer cable for a 1962 cutlass

I am looking for a speedometer cable for a 1962 Cutlass with an aluminum 215 CID V8 and automatic 3speed Roto trans.
Old Apr 5, 2018 | 10:44 AM
  #2  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
I have one but will need to check the condition. Shoot me a PM so that I am reminded this weekend to pull it out of the parts car and inspect it.
Old Apr 5, 2018 | 05:17 PM
  #3  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
I had time to pull it tonight. It works perfect. It does have some cracks in the outer housing near the transmission end but it is not rusted inside at all. I would do $25 and shipping for it.
Attached Images
File Type: jpg
IMGP4100.JPG (1.86 MB, 8 views)
File Type: jpg
IMGP4101.JPG (1.85 MB, 5 views)
File Type: jpg
IMGP4102.JPG (2.41 MB, 5 views)
File Type: jpg
IMGP4105.JPG (2.55 MB, 6 views)
Old Apr 6, 2018 | 12:11 PM
  #4  
HP62's Avatar
Thread Starter
Registered User
 
Joined: Jan 2013
Posts: 9
I"ll buy that, Kenneth Carrier, 13 Carey Street, Apt.2 Newport R.I. 02840
Old Apr 6, 2018 | 12:12 PM
  #5  
HP62's Avatar
Thread Starter
Registered User
 
Joined: Jan 2013
Posts: 9
how would you like payment? and might you have a passenger side headlight bezel?
Old Apr 7, 2018 | 04:54 AM
  #6  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
I have the bezel also but not sure condition. I am going out this morning to pull some other parts so I will get pictures of it also while I am out there. I can do Pay Pal or check. Let me get pictures of the bezel first.
Old Apr 7, 2018 | 05:48 AM
  #7  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
Here are pictures of the passenger side headlight bezel. I would need rechromed for a show car but is fine for a driver. Minor pitting but nothing serious. I would want $30 for the bezel and shipping. If you want this and the cable both I would do $67 shipped to your door.
Attached Images
File Type: jpg
IMG_0852.JPG (1.38 MB, 5 views)
File Type: jpg
IMG_0853.JPG (1.39 MB, 6 views)
File Type: jpg
IMG_0854.JPG (1.50 MB, 5 views)
File Type: jpg
IMG_0855.JPG (1.36 MB, 5 views)
File Type: jpg
IMG_0856.JPG (1.42 MB, 6 views)
Old Apr 9, 2018 | 04:18 AM
  #8  
HP62's Avatar
Thread Starter
Registered User
 
Joined: Jan 2013
Posts: 9
that sounds great. I do PAYPAL could you send me a payment request? Additionally, do you have multiple parts cars or one 62? and how is the interior? The reason I ask is that This 62 convertible is my wife's car and I'm trying to fix up the things that are lacking. Our steering wheel is cracked and warped would the one in your vehicle be in better shape? The headlight mounting frames that are behind the headlights are very rusted and were from another vehicle, might you have these ? both passenger and drivers side? I guess I am looking for quite a few parts. How is the gas tank? Ours was rusted so bad and at the time we could not find another so I put a new 78 ElCamino in but it sits a bit too low
Old Apr 9, 2018 | 12:32 PM
  #9  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
No gas tanks but I do have the headlight bucket assemblies. None of my interior parts are good on the 62. I have a 63 parts car that has red driver quality interior at best but is not the same pattern as 62. I will check on the headlight assemblies. I am working long hours again at work so don't hesitate to send me a PM or email. I can get forgetful when I work like this. jensenracing77@yahoo.com
Eric
Old Apr 9, 2018 | 04:27 PM
  #10  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
Here are pictures of the headlight buckets. If you want these also, Lets make it $100 shipped to your door for everything
Attached Images
File Type: jpg
IMGP4117.JPG (2.69 MB, 1 views)
File Type: jpg
IMGP4118.JPG (2.63 MB, 2 views)
File Type: jpg
IMGP4119.JPG (2.60 MB, 2 views)
File Type: jpg
IMGP4120.JPG (2.54 MB, 3 views)
Old Apr 10, 2018 | 06:19 AM
  #11  
HP62's Avatar
Thread Starter
Registered User
 
Joined: Jan 2013
Posts: 9
ok Eric, the headlight mount assemblies look good and the $100 is a fair price for the items. I guess you can send me a PayPal request? My shipping address is:
Ken Carrier
13 Carey Street, Apt. 2
Newport R.I. 02840
Old Apr 10, 2018 | 07:38 AM
  #12  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
Originally Posted by HP62
ok Eric, the headlight mount assemblies look good and the $100 is a fair price for the items. I guess you can send me a PayPal request? My shipping address is:
Ken Carrier
13 Carey Street, Apt. 2
Newport R.I. 02840
I will need your pay pal email address to send the request. That or just send it to jensenracing77@yahoo.com

Thanks
Old Apr 11, 2018 | 04:29 PM
  #13  
jensenracing77's Avatar
Registered User
 
Joined: Feb 2009
Posts: 11,886
From: Brazil Indiana
I got the payment. I will get it shipped Thursday.
Thanks
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WillCut
Transmission and Driveline
0
Jul 6, 2016 06:11 AM
kartmaster
Transmission and Driveline
0
Dec 8, 2012 08:54 AM
wolfman98
General Questions
8
Nov 18, 2009 05:06 AM
Pfiffle
Drivetrain/Differentials
4
Mar 13, 2008 11:22 AM
ct1979
Cutlass
0
Dec 21, 2006 03:08 PM


Thread Tools
Search this Thread

All times are GMT -7. The time now is 09:03 AM.