Looking for brake distribution switch connector
July 11th, 2016, 03:36 PM
#1
Registered User
Thread Starter
Join Date: Jul 2009
Location: Colorado - Front Range
Posts: 2,391
Looking for brake distribution switch connector
Hi all,
1968 442
I just found that my connector for the wire that connects the brake distribution switch (power drum brakes all 'round) to the engine side of the fuse block was damaged
when I disconnected it, and needs to be replaced. The metal contact inside the rubber boot has disintegrated.
I don't want to make a permanent or even semi-permanent connection by attaching the wire directly to the terminal. That would be "poor form," LOL!
I'm hoping someone has one they can part with, or a good source to obtain a new connector to replace the broken one I have.
Any and all leads welcome.
1968 442
I just found that my connector for the wire that connects the brake distribution switch (power drum brakes all 'round) to the engine side of the fuse block was damaged
when I disconnected it, and needs to be replaced. The metal contact inside the rubber boot has disintegrated.I don't want to make a permanent or even semi-permanent connection by attaching the wire directly to the terminal. That would be "poor form," LOL!
I'm hoping someone has one they can part with, or a good source to obtain a new connector to replace the broken one I have.
Any and all leads welcome.
July 11th, 2016, 04:17 PM
#2
Registered User
Join Date: Sep 2009
Location: Austin, TX
Posts: 331
I have a contact and boot from the harness i just replaced on my 67. It's laying on my garage floor somewhere. Has about two feet of wire as well. You're welcome to it, I'll even cover the cost of mailing if you want it.
Tim
Tim
Thread
Thread Starter
Forum
Replies
Last Post
Octania
General Discussion
0
November 6th, 2015 06:37 PM
garys 68
Brakes/Hydraulic Systems
10
September 18th, 2012 10:20 AM
dgy
Brakes/Hydraulic Systems
5
April 6th, 2012 11:03 AM
Bluemeanie
Brakes/Hydraulic Systems
9
November 5th, 2011 09:25 AM
