needing a 69 350 exhaust manifold for a cutlass it is the cross over manifold looks like this

 

You want the right side (passenger)? I have them in average condition. $15+shipping. Where are you located? If i am far away you may find someone closer and save some shipping.

 

I'm located in Nebraska yes it is the passenger side let me know how much shipping will be I'll take it would you have the driver side one also

 

I have the driver side but from a 70-72. They are the same but i think the original 69 had a flapper plate in the outlet. If you are not worried about the flapper this would be the same other than that. Also $15. $30 total+ shipping. I will have to look up what shipping will be.

 

Ill take both thank you shipping address

Carl Schroer
1908 E 34th st
Kearney, NE 68847

 

I just went out and got them out. the driver side has a broken bolt. I will try to get them out Monday at work. I have another driver side that is real nice but it is a little newer. It would fit and function the same but has a slight differant look. I will get pictures for you after i get the bolt out or if you want the newer one i could get pictures in the morning.

 

If you could get the bolt out that would be great

 

just wandering if you had any luck getting the bolt out

 

We were out of acetylene till today. Unfortunately i was not able to get them out. They are broken off worse than they were. They will need drilled out. You may be better finding another set. I don't have time right now to work on them more. There should be several guys here that have them. I have a near mint set but they are much more money. I don't mention them to often because i want $150 for them.

 

I have some down here in sunny south Florida. E-mail me for pics, etc: drolds1@bellsouth.net. Thanks, Bob.

 

Do yo still have the pass side that's the one I need the most

 

Jensenracing Are you still wanting to sell just the passenger side manifold that's the one I really need

 

I had the same issue two months back.

I bought one passenger side manifold off ebay. I really needed it at the time so I paid $126.00 plus shipping. Then I paid $40.00 to have it planned / surfaced and the bolts taken out. It is media blasted and has new studs with brass bolts.

At the same time I bought a set of Thornton reproduction manifolds. I used the Thorntons and therefore still have the stock manifold. Give me a PM if you are interested.

 

Sorry for missing the last post. It would be best to get one from the other guys. My passenger side had a block off plats and i broke the bolts trying to get it off. I have always had good luck getting them out with a torch but not this time.

 

Check out the reproduction manifolds.

 

I have a set of 69 350 exhaust manifolds that are Hurricane Katrina survivor's... The were stored in the attic, so they remained high & dry even though there was 10 feet of water below. If interested, PM with your email address & I'll send a few pictures.

 

Here are a few pictures of the fruits of my labor. In the end I put on a pair of reproduction manifolds I bought off ebay for what this one manifold cost to buy, ship, surface, and put new studs in it. Now it sits on a shelf in a plastic bag so it doesn't flash rust on me.