I have copies of the original pattern/template from Oldsmobile needed to correctly cut the A/C ductwork on 70-72 Cutlass/442 and to install a factory 8 track player in its correct location. Also included is the 3 page installation instructions. $12.50 shipped within the lower 48. Higher shipping outside the US.

 

Very interesting and useful. I'm sure this makes for a much better installation on A/C equipped cars than trying to judge the correct valance cuts by the "after the tape deck is installed" method.


Are the A/C valances on factory installed tape deck cars also cut, or did they use specific pre-molded A/C valances at the factory?

 

When a car was factory optioned with both Air Conditioning and the 8 track tape player, 2 special lower vents were used. Part numbers 406644 and 406645. When an Oldsmobile dealer installed the tape player, the original long vent was cut to the instructions.

 

ttt

 

bttt

 

bump

 

Interesting that the instructions appear to have you cut the vents with a step or notch whereas the numbered factory pieces are a simple curved cut.

Tony, is what you are selling the actual instructions or a copy of them? I may be interested.

 

I had copies made from the actual GM prints. I do have the originals but they are nfs. The copies are exact size of the originals.

 

Bttt

 

ttt

 

ttt

 

Bttt

 

ttt

 

I still have a few of these in stock, copied from the original NOS instructions.

 

bttt

 

I need to get a copy of those instructions. Just new to this site. How do I get them. Thanks

 

PM sent with payment instructions.

 

Ttt

 

I have sold several of these and all have had perfect results.

 

ttt

 

Interested in a set if you still have any
Thx

 

Still available? I need this/

 

PM sent

 

Do you still sell these documents? If so I would like a copy.

 

I need a copy if they are still available?

 

I have a copy of those papers that I never used. You are welcome to them, please send me your address and I'll ship these off to you.

 

Yes I would be interested to.
I know this is an old post but still be nice to have.
thanks

 

Here too..............please.

 

For some reason my notifications to this thread have not been delivered to me. I still have copies. If interested text or email me. My info is below.

 

Wondering if you still have template for installing 8 track 1970 Cutlass.
badker08@gmail.com
Thanks Bob

 

Suggest you PM the seller too.

 

Yes I still do. Im rarely on here anymore so please Email me @ Bonafide442@yahoo.com and we can compete the transaction.

 

So your print, you just lay on the vent and cut exactly where it shows (for 8 track set up).

thanks

 

I glued a paper pattern (spray glue) to my lower vent before I cut it out.



Installed