Oldzman71

Just putting a feeler out there! Thinking of selling the motor in my sig pic to start the new motor early have not ran the motor yet but have decided to do other stuff to the car and I am not pushing for it this year. I don't need to sell this motor but if it goes great if not ill use it for now. $7500 717 383-6367 located in pa.

Short block

455 block 4.155 bore restricted mains (not filled) coated dura bond back grooved cam bearings arp main studs/head studs brass freeze plugs
4.250 N Crank 10/10 cross drilled oil holes opened up, drilled for pilot bearing roller bearing installed
6.735 Eagle H beam rods
coated rod and main bearings
Aries flat tops sealed power moly rings 12:4.1 compression
8qt Tig welded pan blue printed pump/pickup, hardened pump shaft
Billet rollmaster timing chain roller cam button
Custom erson solid flat tappet .600 int/.600exh
Csr electric water pump
Ati super damper
Fuel pump block off
Btr dist hold down
Btr timing tap
Summit billet distributor
Cometic 4.200 .050 head gaskets
Rocket racing front plate

Top end

A heads ported by the hunts in Ohio all tricks done heat riser blocked exhaust divider welded heads flow 286@.700.
Milodon stainless valves
2.07 int
1.71 exh
Isky springs locks retainers/ guide plates
Dick miller .040 restricted push rods .083 wall
Jomar pro series stud girdles/ Jomar locks 7/16 studs
Harland sharp roller rockers
Moroso sheet metal valve covers
Victor intake 4150 flange milled to fit under OAI hood
Btr alum water neck/stainless lines
Custom built 1100 pro systems carb/magna fuel boost ref regulator 10-an fuel rail fittings russel filled gauge
Holley throttle bracket