When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
This was built for a 72 project car of my brother's who suddenly passed away a few years ago. The owner of the car now is going a different route so the engine is for sale. The block is a machined 39 degree 425 with 455 internals, eagle crank and rods. D cup pistons, Pro Comp aluminum heads, flat tappet cam with 600 lift, Offy intake with dominator Holley carb on it. Rotating assembly was balanced along with stick flywheel. I do not know specs on cam or actual compression ratio. Engine was run for break-in only and started a few times after that. Crank is setup for manual trans. Location is central NJ its a steal for $1800. Engine still sitting in car. He was going to run a 430 rear gear thus the high lift cam. Ask any questions you may have, Thanks
Last edited by oldcutlass; Jun 2, 2025 at 02:37 PM.
Reason: restored deleted info
