stonecad

I've decided to let these go. I have received a few requests already and I do not know what their value is or should be so I will list the items that I need for my 1967 442 sport coupe and see where this gets me. Whoever is comfortable offering me the most in return will get them. The Hood & W30 are the only items that I would consider to be a direct swap.


67 442 parts needed
louvered Hood
W/X Manifolds
drivers side fender & post door
year correct carb
engine brackets (all)
Clutch Z-bar, fork (entire assembly) - I have the pedal
new dash instrument panel for a rally gauge cluster - my car is a factory rally gauge car but the panel is trashed
original wood grain ('68) steering wheel to match my dads
grill and grill bar
headlight bezels (442 only)
67 W30 air cleaner (plan to make my car a trak pack)


There is a distinct possibility that these are Pre-Production examples and I do not have any more info than what was posted in the thread on this site other than the attached diagram that shows a pre-production manifold without the W/X casting. I will leave that up to the barterer/buyer.


I wont sell on Ebay and if I cannot get something I want and can use in return I will hang on to them.

tru-blue 442

I have wanted to see the other side of these manifolds.
Do they have divided runners? just curious. Good luck with your request.
I do have one headlight bezel for a 67 442 if needed.

stonecad

They do not have the dividers in them. I will take some pics and show them.


Thanks for bringing that to my attention

stonecad

Here are the shots of the back side

stonecad

In my web searching I came across the same casting revision 389268 RH D1 as mine except the one I found has the W raised on the end. so far still 1 of 1's for both sides.