Hello all, I know this is a very specific question but has anyone ran a 2013 6.2l and a 2009 4l80e together? I'm looking for suggestions on a good budget friendly torque converter? I also need a tailshaft yoke for the 4l80e. My build has been stalled because of these two parts because I can't get any feedback. Any good ideas please!!!!!

 

Go to the conversions and hybrids section of LS1tech.com. There are only a few folks on here with any LS swap knowledge.

Joe

 

Joe,

Thanks I will give it a try.

Fred

 

Freddy,
I would give you the same advice as I do people asking about camshafts. Call a couple of torque converter manufacturers, tell them your entire combination and ask them to recommend a converter. They are the experts and want to sell you something that you will love. I would bet that 99% of the time they are right on the money.