1984 Delta 88 Parts
#1
1984 Delta 88 Parts
Hi;
I have a 1984 Delta 88 I am parting out. The motor and trans is going onto my Cutlass, the interior is going into my 78 Delta. What I have left is driver side sheet metal, rear axle, deck lid, hood, all glass minus the windshield, front header, core support, and rear valance with tail lamp assemblies. Car was white, all parts are in very good condition. Also have 3 of the good quality stainless steel wire hub caps.
Thanks
I have a 1984 Delta 88 I am parting out. The motor and trans is going onto my Cutlass, the interior is going into my 78 Delta. What I have left is driver side sheet metal, rear axle, deck lid, hood, all glass minus the windshield, front header, core support, and rear valance with tail lamp assemblies. Car was white, all parts are in very good condition. Also have 3 of the good quality stainless steel wire hub caps.
Thanks
#3
Yes
Just an update; ... The body was scrapped today, however I have the full interior, complete set (front and rear) of like new red pillow tops, 6 way electric drivers seat.
I pulled anything of value, door (body by fisher) sill plates, most trim, all plastic interior trim, door panels and dash cap, and carpet. Only thing not savable was the head liner.
Saved the front header panel and rear fiberglass. Tails lamp assemblies were vandalized and destroyed. Also saved the hood and trunk lid.
Also saved the the HD 10 bolt posi-traction rear axle.
Just an update; ... The body was scrapped today, however I have the full interior, complete set (front and rear) of like new red pillow tops, 6 way electric drivers seat.
I pulled anything of value, door (body by fisher) sill plates, most trim, all plastic interior trim, door panels and dash cap, and carpet. Only thing not savable was the head liner.
Saved the front header panel and rear fiberglass. Tails lamp assemblies were vandalized and destroyed. Also saved the hood and trunk lid.
Also saved the the HD 10 bolt posi-traction rear axle.
Last edited by 78Delta; September 30th, 2015 at 12:31 PM. Reason: Info Update
Thread
Thread Starter
Forum
Replies
Last Post