bellhousing question
#1
bellhousing question
I have a BOP bellhousing it is made for a cable operated clutch , it has a starter hole for olds,pontiac and buick on the other side, I was wondering what it came from or what transmission fits it, it is about 6.5 inches deep.
any info would be great.
any info would be great.
#7
Jeep in the middle 80's used some 3.8 Buick V6 engines with five speed transmission it used a similar bell housing. I believe it used a hydraulic clutch, not for sure. It was uncommon because Jeep didn't use very many of the Buick engines. The GM engine they used the most of was the 2.8 Chevy engine.
Last edited by 70 cutlass s; March 1st, 2010 at 03:59 AM.
Thread
Thread Starter
Forum
Replies
Last Post
RAMBOW
Transmission
6
December 9th, 2009 12:26 PM