72 Cutlass Power Door Lock issue
#1
72 Cutlass Power Door Lock issue
I was installing my power door lock solenoids in my 72 Cutlass Supreme and after bolting the unit to the door with the actuator rod attached to the latch mechanism the solenoid rod was fully extended and the latch was pulled down in the fully locked position. It would appear to me that the actuator rod may be slightly too short not allowing the solenoid rod to move upward. I have had these for years waiting to add them to this project and don't remember where I got them. The solenoids line up perfectly with the door dimples which I pre drilled before paint. I have attached photos of the rod and its length and the solenoid itself. Looking for someone to verify what I have here. I'm hoping the rod is the issue and somebody has the correct one for sale.
Thread
Thread Starter
Forum
Replies
Last Post
goldie442
Parts For Sale
0
August 21st, 2015 11:01 AM
ros6872
Parts Wanted
1
May 23rd, 2012 12:02 PM