It ain't fast, but it makes a lot of noise getting there...
It ain't fast, but it makes a lot of noise getting there...
Decided to give the new carburetor another spin on the interstate since the last time I did it I spun my harmonic balancer apart, it ain't fast, but it makes a whole lotta noise getting up to speed. 
https://www.youtube.com/watch?v=vRSmuNNcsHQ
Pardon the wind noise, it was very windy and my door seals are er... Pretty much dust at this point.

https://www.youtube.com/watch?v=vRSmuNNcsHQ
Pardon the wind noise, it was very windy and my door seals are er... Pretty much dust at this point.
Yeah, runs great, idle is a bit rough at times, not sure why, but I'll figure it out eventually. Just gotta get an alignment, replace the heater hoses, and probably swap out the air cleaner 'cause I've heard some horror stories about those edelbrock cleaners like the one I've got.
Thread
Thread Starter
Forum
Replies
Last Post
CutlassS1972
Transmission
18
Aug 13, 2015 11:08 AM
jaunty75
General Discussion
5
Jun 7, 2013 01:57 PM
Aussie67Delta88Custom
Big Blocks
0
Nov 15, 2007 05:49 AM



