Has anybody used the reproduction inner fender wells from OPGI on a 1970 cutlass supreme? I was curious about how well they fit or did it take a while to manipulate them into place! Any replies are greatly appreciated!

 

I think with Olds being plastic, you can adjust them pretty good. But I order, a set when I had a Elco, which are metal, and I had a real hard time getting the holes to line up.

 

If OPGI is involved, you can expect unexpected back orders, poor fitment, lies about both, and a "don't give a shiit" attitude from them.

I will NEVER use them again.

 

I have nice used original black inner wells, send me a PM if interested, thanks Nick.

 

Get them from Rock Auto. They are The Parts Place pieces and they are pretty nice.They are also cheaper than anyplace else I have found - especially OPGI! You need to look under Cutlass to find them. For reasons that only Rock Auto might understand, they do not show up under any other A body car.

 

Rand, could you post a link? I have hunted and cannot find them, thanks.

 

I guess I asked this question a little too late! As I already have the new OPGI ones laying in the garage! Supposed to rain tomorrow, so I’ll jack up and pull front tires and then I’ll know the answer! Thanks for the replies! I was just hoping someone on here actually use the ones from OPGI

 

Here is the Rick Auto link

https://www.rockauto.com/en/catalog/...ner+fender,823

It's under F85, Body,Inner fenders

Hope it helps

 

Thank you sir!