66 98 Convertible is 99% finished
#1
66 98 Convertible is 99% finished
Finally far enough to show off a little.
Rebuild motor, trans, rear end, steering box.
New radiator, water pump, top boot and well.
Polished stainless and most chrome was renewed.
Frame off and painted, new interior like original. Went through several painters....The rotisserie was a much needed tool.
Removed non factory AC.
New dual exhaust and proper manifold.
The list goes on and on $$$$$$$$$$ and I was only going to paint it!!!!!
See the photo album for 66BOAT.
Any comments are welcome. Much thanks to Bruce for his advice.
Rebuild motor, trans, rear end, steering box.
New radiator, water pump, top boot and well.
Polished stainless and most chrome was renewed.
Frame off and painted, new interior like original. Went through several painters....The rotisserie was a much needed tool.
Removed non factory AC.
New dual exhaust and proper manifold.
The list goes on and on $$$$$$$$$$ and I was only going to paint it!!!!!
See the photo album for 66BOAT.
Any comments are welcome. Much thanks to Bruce for his advice.
#5
Give Fusick a try - they are still listed as a distributor for the manuf. - R.E.M. Automotive, 20 Landings Drive, Annville, PA 17003 Phone 717-838-4242 Their website gives a list of distributors. They do not generally sell retail.
Last edited by bigoldscruiser; October 19th, 2013 at 04:49 PM. Reason: updated info
#6
How did you make out with the trunk cardboard? If you have to go to R.E.M., ask to speak to Mike. My friend and I sent them the original pieces to make the templates for the convertible and the Holiday Sedan.
Thread
Thread Starter
Forum
Replies
Last Post