A process to troubleshoot old tail lights
#1
A process to troubleshoot old tail lights
Maybe not the best process, but here are my usual steps:
1. Check taillight fuse
2. Check bulb
3. Check signal to bulb + wire
4. Check bulb ground
5. Check / Deox clean front ribbon cable connections
6. Check / Deox clean rear ribbon cable connections
7. Deox turn switch & connector wires
8. Deox brake switch & connector wires
9. Check brake switch function with multimeter. Bend switch brass tabs inward for good connection to wires
10. Check power to brake light switch
If anyone has timesaving or labor saving improvements, I'm all eyes.
Hope this helps
cf
1. Check taillight fuse
2. Check bulb
3. Check signal to bulb + wire
4. Check bulb ground
5. Check / Deox clean front ribbon cable connections
6. Check / Deox clean rear ribbon cable connections
7. Deox turn switch & connector wires
8. Deox brake switch & connector wires
9. Check brake switch function with multimeter. Bend switch brass tabs inward for good connection to wires
10. Check power to brake light switch
If anyone has timesaving or labor saving improvements, I'm all eyes.
Hope this helps
cf
#2
For reference "deox" is an deoxidant spray for electrical connections. Works well. I think the brand is DE 05 or similar. Works especially well if you lightly dremel the contacts.
Thread
Thread Starter
Forum
Replies
Last Post
Oldssupreme
Parts For Sale
0
April 3rd, 2015 08:36 PM
junkyard72
Small Blocks
11
April 3rd, 2013 11:16 PM
1965cutlassragtop
Small Blocks
54
July 1st, 2012 02:00 PM
|-K|=K
Small Blocks
9
December 22nd, 2010 01:35 PM