oil pressure guage
January 2nd, 2013, 04:08 PM
#2
No pics, but it's really easy.
Go to Home Depot and pic up a male/female/female brass "T" fitting and a short brass male/female pipe. Both should be 1/8 inch.
Put the brass pipe in the block afte removing the OE sending unit. then put in the "T" fitting and the orginal sending unit on the top and the oil gauge unit on the side.
Use teflon tape on treads. Not too much
Go to Home Depot and pic up a male/female/female brass "T" fitting and a short brass male/female pipe. Both should be 1/8 inch.
Put the brass pipe in the block afte removing the OE sending unit. then put in the "T" fitting and the orginal sending unit on the top and the oil gauge unit on the side.
Use teflon tape on treads. Not too much
Thread
Thread Starter
Forum
Replies
Last Post
