You just use anchors Glenn, throw away the mounts.... BTW Good one!!

 

I'm having a hell of a time finding the proper headers for my 72 Cutlass Supreme. EVERY shop I go to tells me the engine is offset so headers won't fit......Bazinga!!

 

Allan, I am going to say we are pretty much close to a tie on the most aggravating Joe P. question. He will have to render a verdict.

 

I was going to post that I was surprised no one mentioned motor mounts!

 

Joe, it would be interesting to know how many post you have for motor mounts, headers for a Cutlass Supreme and stripes. Too bad there is no way to sort those. Thanks for being here and sharing your knowledge.

 

I want to thank all the moderators, not only for disbursing valuable knowledge, but also doing a good job of keeping this a friendly site!

I also want want to thank all the knowledgeable people who post on this site. I have learned quite a bit from everyone.

As for the number of post, I just went over a 1,000, and didn’t even know it. An older thread, had a 1,000 posts being in the top 160, but I think a quick estimation would put me somewhere around the top 200, at the very bottom of page 6.😮

And from a Bill Murray line

”Well, I have that going for me.”

 

What aftermarket headers fit the Cutlass Supreme because of the "offset" engine mounts?

 

I also would like to thank the fine folks on the site as well.
According to Dan's spreadsheet though, I may have to much time on my hands.

 

Hey Joe, should I paint the stripes on my aftermarket Thornton OAI w-25 hood wood grain to match the sides on the Vista Cruiser I am putting it on?




...come to think of it, that would not be a bad look.