1964 Cutlass Convertible for sale
#1
1964 Cutlass Convertible for sale
First time poster but long time Oldsmobile fan. I have a 1964 Oldsmobile Cutlass convertible for sale. The car is a barn find and don't have a ton of information regarding the car. The car is very straight / clean and I will try to post some pictures of the car if I can figure that part out.
The good:
- clean body
- bucket seats and back seat
- engine and trans
- bumpers
- has new convertible top in box
- have new complete floor pan with braces
The bad:
- bill of sale
- not currently running
- needs side moldings
- no top currently on car
- floor pans need replacing
- no vin on car, but have replacement vin to go with the car
- minor rust blistering in front of the rear tire on the driver's side
I am asking $4,200 but will consider reasonable offers. You can also be reached at 925-8zero8-five9six9
The good:
- clean body
- bucket seats and back seat
- engine and trans
- bumpers
- has new convertible top in box
- have new complete floor pan with braces
The bad:
- bill of sale
- not currently running
- needs side moldings
- no top currently on car
- floor pans need replacing
- no vin on car, but have replacement vin to go with the car
- minor rust blistering in front of the rear tire on the driver's side
I am asking $4,200 but will consider reasonable offers. You can also be reached at 925-8zero8-five9six9
Last edited by Barker327; February 1st, 2024 at 07:08 PM. Reason: add photos
#5
The VIN plate on a '64 Oldsmobile should be on the driver's side door hinge pillar, not on the dash as it was after 1967. Has it been pried off? Why would someone do that? I realize that you probably don't know why the VIN plate is missing. Just musing here.
Is the replacement from another '64 Cutlass, or is it a reproduction that contains the original VIN?
Is the replacement from another '64 Cutlass, or is it a reproduction that contains the original VIN?
Last edited by jaunty75; November 15th, 2023 at 06:52 AM.
Thread
Thread Starter
Forum
Replies
Last Post
jaunty75
General Discussion
5
May 10th, 2017 05:36 PM