67 cutlass clips
#1
67 cutlass clips
anyone know where or if there's another fit for the push on side molding clips for the two side pieces in front of the rear wheel well and rear of front wheel well on 67 442. can't get behind to nut on. sorry should have been more specific. have two clips looking for two or three more. 66 olds cutlass doesn't fit and know one re-pops them. used to be on help rack at local auto body supply store.. W&E sales had them part number 99-181 called them no longer available. new paint and too thick; can't get push head to go in and catch, any tricks to finishing
Last edited by vickycar; May 25th, 2018 at 02:22 AM.
#2
https://www.opgi.com/cutlass/1967/moldings/hardware/
Are any of those what you want?
Can we see a picture of what you need?
Are any of those what you want?
Can we see a picture of what you need?
#5
anyone know where or if there's another fit for the push on side molding clips for the two side pieces in front of the rear wheel well and rear of front wheel well on 67 442. can't get behind to nut on. sorry should have been more specific. have two clips looking for two or three more. 66 olds cutlass doesn't fit and know one re-pops them. used to be on help rack at local auto body supply store.. W&E sales had them part number 99-181 called them no longer available. new paint and too thick; can't get push head to go in and catch, any tricks to finishing
I did get used stuff from Henry, but didn't want to put rusty clips on, they would only rust again. They were helpful in the Auveco hunt though.
Tim
Thread
Thread Starter
Forum
Replies
Last Post
oldzy
Chassis/Body/Frame
0
April 24th, 2010 09:13 PM
Threejdsolds
Parts Wanted
2
December 11th, 2008 09:22 PM