anyone know where or if there's another fit for the push on side molding clips for the two side pieces in front of the rear wheel well and rear of front wheel well on 67 442. can't get behind to nut on. sorry should have been more specific. have two clips looking for two or three more. 66 olds cutlass doesn't fit and know one re-pops them. used to be on help rack at local auto body supply store.. W&E sales had them part number 99-181 called them no longer available. new paint and too thick; can't get push head to go in and catch, any tricks to finishing

 

https://www.opgi.com/cutlass/1967/moldings/hardware/

Are any of those what you want?

Can we see a picture of what you need?

 

no i tried all the parts places, Fusnick sells them for 66 but 67's are same length but push in nub is larger, i'm going to post pic when i get home, thanks anyway

 

I just sent you three

Larry

 

My car was missing all stainless and clips. Once I tracked down the trim, I bought every clip Fusick had, then went through the Auveco catalog to match up the rest. That was a few years ago, but I think I have the copies of the Auveco pages I used to order them. I found enough from both sources to get all the trim installed.



I did get used stuff from Henry, but didn't want to put rusty clips on, they would only rust again. They were helpful in the Auveco hunt though.

Tim

 

yes thanks larry but two of them were smaller, i believe from 66. matched up with two i bought from FUSNICKS and were same size. trying ti send pic. bottom one in pic has bigger end