Stupid question on distributor timing
Thread Starter
Registered User
Joined: May 2013
Posts: 270
From: Charlotte, NC
Stupid question on distributor timing
This might be a silly question, but on the distributor, which is the number one cylinder? Or rather, which two cylinders flank the little dwell flap? Then I can work out where the other ones are on a 67 toronado 425. Guess all the olds engines would be the same. Just did my intake manfold gasket…again. This time did not use the rubber strips they gave me with the kit. Last time they got pressed out on the sides. Engine leaked oil and ran terribly.
Took photos of the position of the rotor and distributor, but forgot to make a mark on the distributor cap for the number one cylinder.
Took photos of the position of the rotor and distributor, but forgot to make a mark on the distributor cap for the number one cylinder.
Lansing built
Joined: Nov 2011
Posts: 3,331
From: Grand Ledge, MI
Just to make sure it's timed correctly, I will cheat instead of typing and use the tutorial on line.
http://www.junkyardgenius.com/ignition/dist01.html
Pat
http://www.junkyardgenius.com/ignition/dist01.html
Pat
Thread
Thread Starter
Forum
Replies
Last Post
gearheads78
General Discussion
36
Dec 18, 2009 06:15 AM
