w/z manifolds on g heads- divider question
#1
w/z manifolds on g heads- divider question
my g head exhaust crossovers are blocked with resbond. without welding on the heads or the exhaust manifolds, how would you go about filling the gap between the center dividers on the heads and the center dividers on the w/z manifolds? this is for use with ernie's 425, dual exhaust.
tia,
bill
tia,
bill
#3
Well without welding I only know that face can be milled down so center divider is flush. I had this done on a 67 442. It made the Hooker headers fit better than before. I dont know how this will work with manifolds...
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post