Hey I am looking for Aluminum heads I am final building a 70 455 that i have had for a few years I see the new Edelbrock 61025 heads are not shipping for other reasons I can't wait till May does anyone have an y good options. The goal is as close to 400HP on pump gas i can get.

Thanks for the input.

 

Contact Mark Remmel (cutlassefi) or Bernard Mondello Racing, either should be able to assemble a set of Speedmaster heads with quality parts and workmanship, to meet your needs. ,Avoid Mondello Performance

 

You don't need aluminum heads to get 400 HP out of a 455.

 

Thanks for the information I have dealt with Mark a long time ago I lost all his info I had as for the 400 HP that’s a conservative estimate once I can find out what heads I can purchase we will build the rest of the engine according

 

PM me and I’ll send you my email and phone #.

 

Thanks Mark I sent you a pm.

 

I have a completed set of reworked C heads with small valves. Ran once on the dyno. Made 400HP with my combo. Probably would have made more as that was the initial pull. I had the crank bearings too tight and had to stop. Switched to aluminum heads after that. I am in NC as well...near Greensboro. If you are interested in them PM me.

 

Thanks for the offer I keep it in mind i really want to see it i can find some aluminum heads.

 

Have some mildly ported F heads w/ roller rockers. Has springs for a roller cam. ready to bolt on.. 4K and your engine value may increase with time. LOL