Can this even be done?
#1
Can this even be done?
I have a 1969 Cutlass rear bumper, Excellent for rechrome... I have the two cutouts from a 442 bumper. Can these be welded into my existing bumper, ground smoooth and rechromed to have a 69 442 bumper? There are no reproduction 69 bumpers out there! Any advice will be very helpful. Thanks in advance
#2
If you have somebody who's good at welding I don't see why this couldn't be done. The bumper brackets have a tab for the exhaust pipe hangers, but those too could be added by someone with good skills. John
#4
Thanks for the info Joe and 2blu442. My 69 cutlass bumper is very near perfect and the cutouts have been cut out of a 442 bumper. They measure about 6w X 4h. Sorry i was confusing. Still be done? Thanks
#6
#7
Damn rights it can be done, Find a damn good welder and grind that crap carefully, afterwards sand the sh*t down with 40 gritt sand paper and work your way up to 220 sand paper and see how it starts to look, Believe me I done many bumpers it sikkens me
Thread
Thread Starter
Forum
Replies
Last Post