looking for black steering wheel 3 spoke
#3
Steering Wheel
Hi Rich,
Rich here. I removed this very wheel from my '68 442. It is in the same condition as the one you posted a picture of. I measured mine at 15.5" in diameter.
I took more pictures if you are interested in seeing them, but here is one with the tape measure.
There is a thread here on C.O. about restoring this type of wheel. IIRC the member even posted pics of the finished product.
Rich
Rich here. I removed this very wheel from my '68 442. It is in the same condition as the one you posted a picture of. I measured mine at 15.5" in diameter.
I took more pictures if you are interested in seeing them, but here is one with the tape measure.
There is a thread here on C.O. about restoring this type of wheel. IIRC the member even posted pics of the finished product.
Rich
#5
More pics
I'd like $90 plus shipping. After you review the pics below, let me know if you want to proceed. I want to make sure you understand the condition. Shoot me over your ZIP either here or in a PM, and I'll weigh it and get an approximate shipping cost, including insurance for $100.
Rich
Rich
#6
I have a 68 floor shift column with one on it too. I remember a few cracks but not clear on it's condition. Will check tomorrow
Best to email direct lemoldsnut@aol.com
Thanks
Larry
Best to email direct lemoldsnut@aol.com
Thanks
Larry
#7
More damage than I remembered
Rich,
Please see pics below, and check your PMs. I had forgotten about the large cracks around the hub and back side of the "spokes."
No harm, no foul if you decide this one is not up to your needs.
Rich
Please see pics below, and check your PMs. I had forgotten about the large cracks around the hub and back side of the "spokes."
No harm, no foul if you decide this one is not up to your needs.
Rich
#8
I also have a 68 Rosewood wheel it had a few cracks and was repaired at one time prior to me owning it. It is nice but not perfect.
let me know if you are interested
Larry
lemoldsnut@aol.com
let me know if you are interested
Larry
lemoldsnut@aol.com
Thread
Thread Starter
Forum
Replies
Last Post
BeenThere
Parts For Sale
1
September 22nd, 2013 03:33 AM