As the title reads......also, did anyone produce a single 4 bbl intake in aluminum for this engine? I have a friend who says Offenhauser did but I've not seen one only dual quads or trips.


Oh, the engine is an otherwise stock 1961 2 bbl low comp that I'm adding dual exhaust to right now.


Does anyone know if a stock manifold will clear one of those finned aluminum covers over the valley?


Thanks!

 

I have only seen stock iron intakes for single quads, and those always have the smaller throttle bore holes and mounting bolt pattern of the 4-jet. You would need an adapter and perhaps opening of the four holes to run a Holley, etc.

 

do 371 intakes interchange or is there a spacer needed?

 

There was a deck height increase, hence you can't use the 3x2, etc. from the old 371.

 

Might have a 4bbl stock intake if interested.

 

PM sent.

 

If that doesn't work out, I have a stock 4-bbl intake for the 394.

 

There is one posted on Craigslist for Portland Oregon pretty cheap too

 

I'd just like to thank MrOlds88 for helping out another forum member to locate parts. Super guy to deal with.