Looking for wiper motor arm
Current arm hits cowl screen must not be original.

 

Might just need to be adjusted, my buddies hits the chrome on the windshield. If you are interested in a new wiper arm still hit me up as i know where some are

 

Not an adjustment issue arm is to long and straight up it is above cowel 1/4

 

I will talk to my buddy tonight and see if he has one to sell, location of where this would be going? And do you happen to have pics of the wiper arm, kinda curious on what yours looks like.

 

Arm is approx. 2 1/4 long from pivot to hole


Have problem getting pics attached

 

I have arms , w/wiper parts for 69.

Greg

 

i will measure the ones on my car but i would talk with greg there, might be a little bit til i can get to that part on a car

 

Any chance of throwing a tape measure on it.
If it is shorter than 2.25 I am interested in it.


Located Des Plaines to Gurnee IL

 

Ok...looks like a hidden wiper set-up. The right link, or arm as you call it will have AB stamped on it. The position of that link in the 2nd pic...if the wipers are off in that pic....that link is 180 degrees off. If the wipers are off, that link should point to the drivers side fender. Just to clarify that point, I mean if the wipers are turned off on the dash. Not if the wiper arms and blades are off the car. You will have another prob adjusting them to hide. but first check that link and look for AB stamp.

 

The factory Cowl Screens have a raised area approx 1 1/2 X 2" to allow for the arm to clear. I do not see provision in screen? Is your screen a factory original part?

 

You have the correct arm.

Greg

 

x2

 

X3 on the screen. I suppose it's possible to put the screen on upside down. Maybe the indentation is on the passenger side?

 

Thank you gentleman.


I will put a indent on screen, as it is aftermarket and flat.
Old one had torn hole from rubbing.