edzolz

Anybody in Dallas TX area have a bare 455 block? Just the block with main caps.

therobski

Ed I have a 65 425 block and un-turned steel crank?

ROCKETMAN269V

Ed, I have bare blocks, cranks, cylinder heads, etc. If interested, email me direct: drolds1@bellsouth.net. Thanks, Bob.

ROCKETMAN269V

Depending on what it came out, it could have a 45 deg. or a 39 deg. bank angle for the camshaft/lifters.

Majic Jack

I have the lower block with main caps, Fa 455, tanked and bored 30 over. Located in San Antonio, 210 735 7100.

therobski

Rocketman- all first year 65 425's 386525A are 45 degree CBA with a 842 lifter bore. Same for the 65 400 . Magic Jack out of SA has ED's solution.

edzolz

Thanks all. Just looking to build a 425 from a 455 block. My 425 I've had on a stand since 86 was bored .040 and the cylinders measure at least .006 over, too much for todays pistons.

ROCKETMAN269V

Ed, I have a '71 455 block that is 0.030" over and been hot tanked and sprayed with WD-40. It needs to go 0.040" Thanks, Bob.

therobski

Crap Ed Guess what sitting on the shelve I bought from "Chadman" ? Brand new .30 over Aris 425 pistons with 2CC valve reliefs and a set of totally reworked 400-425 rods that Joe Mondello did his magic before he moved on. Only If they were .40 over !

edzolz

Want to get rid of the rods?

therobski

Ed sent you a PM.

aqua67w30

I hope Mondello special rods are better than Dick Miller special prep rods. I tossed a few of those DM rods through the side of the block.