I have stripped out two of these in the last few months. I have a pr. of buckets that need totally redone, and a ton of smalls, hit me up with what you may need. I will look in the pile. all parts are located in AR. 72761.

 

Hi Looking for the following:
4- Speed Console
Bellhousing
Pedals and all linkage for conversion to Manual Trans
Rear Stablizer bar
Front lower Windshield cow panel
Wheel well opening moldings
Core support (can be damaged, just need to patch rusted support on battery side on current support)
Dual Exhaust manifolds both sides

 

I have the chrome piece where the wipers are if that is what you are calling the cow panel. I may have a full set of driver wheel well moldings. I have a good reparable core support, The rear stabilizer bar can be bought on ebay through Summit for 106.00 plus shipping. Do not have any suggestions on the std. parts or the factory dual. I would do 225.00 for all of it but shipping is going to be a lot for the support. where are you located?

 

Hi,

Do u have the seat belt warning wire harness that runs from the seat pressure sensor switch to the warning light? Also looking for a clean non pitted rear left bumper guard.
Thanks

 

I do not have either of these.

 

Ok thanks. Do you have any door edge guards?

 

The cowl part that I am looking for is the bottom of the windshield and where the windshield wipers mount not the chrome. Do you have pics of the core support. I am getting a freight quote from AZ to VA just in case.

 

It will be from 72761 in AR. I sent you a PM.

 

Do you have any black seat belts?

 

I left the ones in the car. The buckles are a bit rusty looking, So was the other set I had. I also noticed that one had been cut in the back.

 

Thanks

 

Do the bucket seats have headrests? Driveside have power? What are you asking. What type of hood do you have? Do you have the spoiler?

 

looking for the headlight mounting bezel...I need to look, I have one side but not the other. Do you have any? how about a front bumper?

 

Thanks everyone. I found the door edge guards and rear bumper guards.

 

Hi, Any headrests you can part with?