C castings bare - $100

Stock HEI - $25

 

Where are you located? How much for the rockers?

 

$250 seem fair?

 

I think so. I am waiting for a check from a guy for my truck . Don't hold them but if he follows through I will get in touch. That is fair, those are expensive.

 

NP, they aren't going any where. They haven't been run but have been installed. Motor was just sitting there for ages.

 

i pmed you about the m/t covers

 

Sorry forgot to say where I'm located. I'm in Middletown, RI. That rocker kit sells for $599 nowadays so $250 is a great deal. Especially since they are unused.

 

how much for the m/t valve covers?

 

How about $20 for the M/T valve covers? They have been sand blasted so the crinkle finish is not on them. Those who want to send me a direct email can do so at gkeck58@***.net

 

you have been emailed

ill take the m/t covers

 

I'd like the crank. Can I meet you next month when I'm in the area for the OCA Nationals.

 

What condition is the performer intake in? Does it have the egr block off plate?

 

I'm interested in the torker if it's for a big block. . I'd like some pics if you can. Send me a pm. Thanks

 

sent pm and emails for pistons rods ect.


BTW:
I am lost in my own mind........ as well.

 

Ok I'll try and get pics up soon but I need to take the engine apart to do some of that.

Yes the Torker is for a BBO.

The Performer 350 is in great condition, just dirty. Yes it has an EGR block off plate on it.

WTony, good call on my little credo!

 

pm sent

 

Could you pm me a picture of the performer?

 

Put me next in line for the Harlan Sharp shaft rockers ....


Thanks

 

Some pics after I removed the pistons today