Yes, I'm looking for

1.) rusty quarter panels for any '66 or '67 GM A-body.

I need to repair the trunk gutter channels (sides and rear) on my '66 Cutlass, but the side railings that I need are actually a part of the quarter panel. So I'm looking for someone who has the full quarter panel - one that is not rusted in the side trunk channels - even if that quarter panel is rusted in the typical areas (around the wheel well, etc.).

2.) tail panel

I'm looking for the full tail panel (visible only when the trunk is open) that connects the tail lights on both sides of the trunk latch and that connects to the floor pan. Mine is totally disintegrated by rust so I'm looking for the whole piece.

Thanks!

 

i have a tail panel that is missing about an inch on the right 1/4 panel side but is not rotted just cut a bit short. i also have the driver channel , but it is not great. I did see a guy on ebay a bit back that made channels and was selling bent sheet metal that looked pretty good. let me know

bigin1978@hotmail.com

 

Thanks for the reply. I was able to find the tail panel, but I still need the side channels...

if you could get the name of the guy on ebay, I would definitely reach out and see if he has what I'm looking for. Thanks again for the reply.

 

this should be what you are looking for . hope it helps


http://www.ebay.com/itm/TRUNK-GUTTER...item5d31acd329


http://www.ebay.com/itm/66-67-Chevel...item588dc528b6

 

I have a '66 442 shell & a '67 442 shell, both very rough, but I bet they will have the side parts you're looking for. Here is a link to pictures of them. Let me know what you think. They are 5 minutes from my house & I'm warming up the Sawzall as we speak. I'd like to see as much of the car get used before it gets turned into a honda.
Give me a call if you want.
Thanks.
Scott
c. 317-727-7041
See pages 8 & 19.
http://s856.photobucket.com/albums/a...ile%20Uploads/

 

I saw this on page 2....

http://i856.photobucket.com/albums/a...-23-35_332.jpg

It's exactly what I need, but not sure if this will fit my 66 cutlass...do you know if this would work?

 

I'm sorry...didn't read carefully enough - you directed me to page 5 and page 19. It looks like those would work, assuming that the part I need isn't rusted out...If it's possible to get pictures of those gutter channels, I am most certainly interested in them. PM sent.

 

Doug,
I'll try to get pictures tomorrow of those areas & post them here.
Thanks.
Scott

 

I have those parts in NC----several 66--67 parts cars.