Modified Torker Intake (not finished)
February 13th, 2014, 03:02 PM
#1
Registered User
Thread Starter
Join Date: Dec 2005
Location: Macon, GA
Posts: 120
Modified Torker Intake (not finished)
Anyone want to finish this? A lot of the undesirable work has been done.
$75 plus shipping.
One of the bolt hole-to-head locations (red circle) needs building up a bit on the bottom side to restore the proper fastener angle. I got a little wild with my grinder on this one prior to remembering the bolts are not 90 degrees to the head. Shouldn't be a problem to restore that while welding up the heat shield portion of the air gap intake.
*** SOLD ***
$75 plus shipping.
One of the bolt hole-to-head locations (red circle) needs building up a bit on the bottom side to restore the proper fastener angle. I got a little wild with my grinder on this one prior to remembering the bolts are not 90 degrees to the head. Shouldn't be a problem to restore that while welding up the heat shield portion of the air gap intake.
*** SOLD ***
Last edited by 68 D88; February 17th, 2014 at 08:31 PM.
Thread
Thread Starter
Forum
Replies
Last Post
RAMBOW
Big Blocks
17
July 31st, 2011 01:59 AM
svnt442
Parts For Sale
3
July 17th, 2011 04:43 PM
