Takid455

403 I built for a T/A I once had. Engine build has about 3k miles

As it sites it is not streetable due to compression ratio.

You can use short block and install 4A heads or take top end and install on stock 350/403 and have a nice street motor

Bottom end:
balance internals w/ custom Arias flat top pistons. Gapless rings
0.030 over bore

272 duration cam w/bleed down lifters

top end
#6 heads ported, shaved, new valves. intake milled to match and port matched.

Have folder of reciepts

All - 2000
bottom - 1200. as much or as little as you want.
top - 1000

If parted, prefer to sell short block before top end.

No shipping quotes, its heavy, shipping will be high.
sorry, no pictures. Will answer questions and allow parties to stop by and view.

Located in 07840.

Rickman48

By 'bleed - down lifters', do you mean Rhodes?

Takid455

Same concept. Rhodes were too noisy so I installed cranes version. No sure if they are still made.