When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Used 1 time for break in and tuning on an engine dyno.
Some light corrosion on the water passages from dyno coolant and on the outside from age.
Includes bolts, aluminum washers, carburetor studs, and brass plugs
Milled 0.055" on each side to better fit a block that was zero decked. The block it was installed on had a deck height of 10.600", unmilled E heads, and a turkey tray style gasket. Before milling the end seals had too much of a gap to get a reliable seal without really caking on the RTV silicone. Correct me if I'm wrong, but I don't think this would fit a stock block and heads unless you use the thicker intake gaskets from the likes of Felpro, etc.
$300 + SH
Estimate $18-36 UPS Ground for from 48823 depending on distance. Message your ZIP for an accurate postage cost.
Last edited by th3ric3m4n; Dec 1, 2023 at 11:12 AM.
