CompSolidFlatTappet
#1
CompSolidFlatTappet
This is a 1970s vintage CompCams shaft and .921" lifters. Was in my "E" block for break in and about 4 passes at Norwalk until a sub-par fuel system caused extreme lean and burned a hole in a piston; went 12.03/110.70, felt motor start to go away at the top of third gear. This grind likes rpm so would recommend for a built 350 or 400/425 motor of about 12:1 static compression. Camshaft is like new, lifters may have some surface rust. I may have a set of valve springs to throw in as well. $150.00 plus shipping from 31548 in lower 48 (may be expensive) or I can deliver to Murfreesboro. Cam card attached.
Last edited by 67OAI; June 22nd, 2022 at 07:47 AM. Reason: add info
#3
This is a 1970s vintage CompCams shaft and .921" lifters. Was in my "E" block for break in and about 4 passes at Norwalk until a sub-par fuel system caused extreme lean and burned a hole in a piston; went 12.03/110.70, felt motor start to go away at the top of third gear. This grind likes rpm so would recommend for a built 350 or 400/425 motor of about 12:1 static compression. Camshaft is like new, lifters may have some surface rust. I may have a set of valve springs to throw in as well. $150.00 plus shipping from 31548 in lower 48 (may be expensive) or I can deliver to Murfreesboro. Cam card attached.
Thread
Thread Starter
Forum
Replies
Last Post