69 toro parts
69 toro parts
this is the car that i posted was a 68. i figured out that it is a 69. it is easier to list the good parts than the bad ones.
speedo cables for CC
has 5 wheels for cores. a couple would be ok for a driver
door edge guards are in ok shape
has disc brakes but i figure that the rotors are bad?
vinyl top molding for right rear quarter nice
power trunk, i have not tested it yet.
T&T steering column
i think the steering parts are good
transmission 69 OJ 9081
carburetor 7042262
4 bbl intake
there may be some other little parts that are good.
100_5623.jpg?t=1257019718
100_5621.jpg?t=1257019740
speedo cables for CC
has 5 wheels for cores. a couple would be ok for a driver
door edge guards are in ok shape
has disc brakes but i figure that the rotors are bad?
vinyl top molding for right rear quarter nice
power trunk, i have not tested it yet.
T&T steering column
i think the steering parts are good
transmission 69 OJ 9081
carburetor 7042262
4 bbl intake
there may be some other little parts that are good.
100_5623.jpg?t=1257019718
100_5621.jpg?t=1257019740
Last edited by jensenracing77; Oct 31, 2009 at 01:12 PM.
wheels caps and rings are gone.
i just took off the front disc brake set up. i will get a picture or two. i would take $85 plus shipping for the disc brake setup. i don't know if the rotors could be turned or not. i think they may be a little thin. the rotors are very rusty but the spindles and backing plates are good. the inner and outer tie rod ends are included also. they felt tight on the car.
i just took off the front disc brake set up. i will get a picture or two. i would take $85 plus shipping for the disc brake setup. i don't know if the rotors could be turned or not. i think they may be a little thin. the rotors are very rusty but the spindles and backing plates are good. the inner and outer tie rod ends are included also. they felt tight on the car.
Thread
Thread Starter
Forum
Replies
Last Post



