New member..need advice on interior for 64 cutlass
April 15th, 2010, 05:09 PM
#1
Registered User
Thread Starter
Join Date: Apr 2010
Location: Wisconsin and California
Posts: 318
New member..need advice on interior for 64 cutlass
Hello to everyone and I hope your day is going very well. I purchased my first classic car last week. It is a 1964 cutlass, 330, 4v, auto on the column
but that will everntually be changed, factory AC, PS, PB and all functional. So, the car needs a new interior (floor boards are sholwing and foam exposed on seats) and I was hoping those that have replaced interior could recommend a company with quality repros. I have been looking a fusick, OPGI out of Seal Beach CA, and legandary auto interiors. Everything is needed, including the drivver seat bottom spings. I would like to replace the carpet, door panels, seats and rear arm rests at the same time to avoid any variation from changes in lot numbers. Thank you for your suggestions. Also, is it possible to do all this yourself
but that will everntually be changed, factory AC, PS, PB and all functional. So, the car needs a new interior (floor boards are sholwing and foam exposed on seats) and I was hoping those that have replaced interior could recommend a company with quality repros. I have been looking a fusick, OPGI out of Seal Beach CA, and legandary auto interiors. Everything is needed, including the drivver seat bottom spings. I would like to replace the carpet, door panels, seats and rear arm rests at the same time to avoid any variation from changes in lot numbers. Thank you for your suggestions. Also, is it possible to do all this yourself
April 16th, 2010, 04:54 AM
#3
Past Administrator
Join Date: May 2004
Location: Rural Waxahachie Texas
Posts: 10,068
Thread
Thread Starter
Forum
Replies
Last Post
boehm
Interior/Upholstery
2
September 26th, 2009 09:54 AM
66442ragtop
General Discussion
1
April 9th, 2008 02:31 PM
