Hello all
So i am building up a 68 455 block. I am looking to stroke it but i am not trying to go to dick miller as i have found from this forum and another with several complaints about their service. so is there anyone who can help me out and point me in the right direction?? I will be putting this block in a 73 supreme. i have already dropped the crank off at a reputable shop and the block off at another. any advice on rods and pistons i can throw on my N crank? i have two of them, one needs to be cut .010 .010 and i think i will be able to get away with polishing the other one. Any help would be greatly appreciated!! Hope to get tons of advice
Thanks and i will be checking this thread multiple times daily

 

I have the C Heads W the small 1.998 intake. no cam. no intake.