Charlie_brown

this was where i started laying sound deadener, removing the dash and taking out the 350.

Charlie_brown

All in preperation for the BBO!

Charlie_brown

Charlie_brown

stored the 400 and went with a built 350! All nylon braided fuel lines, sumped tank with blue holley pump.

Charlie_brown

I hit a bump in the road when i though i was set to break the cam in and over a month's time i had to take the intake off 3 times for a broken bolt on the egr then i didn't seal the intake down good enough and then i found i had a crack in the back water jacket

Charlie_brown

Done with the motor, i found i had electrical issues when my ground wire for my fans began to smoke. So installed 2 relays and wired one in for the fuel pump while i was at it. And this is were i'm at today i've wired my my digital guages and just need to finish going through setting them up and do an oil change and hopefull i'm ready to put it on the road.

Charlie_brown

This being my first build I was learning as i went. Since coming from the machine shop its been all me by myself and i'm proud to say that. I appreciate all the knowlegde and help i've received from you guys. I've learned alot and just wanted to give you guys your due!

6inarow

That engine should wake your Cutlass right up. I'll be watching for a video of a smokey burnout!