smitty275 - Mark Smith
smitty275 - Mark Smith
anyone here heard from smitty275 (Mark Smith)? he's hasn't been answering any calls/emails/PM's or txts for a couple of months, trying to get my parts from him
ok, got a txt message from smitty this evening. "when i get address of your nearest Fastenal store i've asked for it for the last several months, about every two weeks"
i have not received any responses to any txt's i have sent to his cell number, emails sent to smitho455@att.net, txts sent via email to 3304954582@vtext.com, no replies to PM's sent to him from ROP, CO, or YB
last email contact with him was March.
i sent reply to his txt message stating i sent Fastenal info to his email smitho455@att.net, and for him to let me know he got it.
i sent a txt with the address of my nearest Fastenal to his cell 3304954582@vtext.com
sending him a PM on here, ROP, and YB with info again as well
i'll update when he responds
i have not received any responses to any txt's i have sent to his cell number, emails sent to smitho455@att.net, txts sent via email to 3304954582@vtext.com, no replies to PM's sent to him from ROP, CO, or YB
last email contact with him was March.
i sent reply to his txt message stating i sent Fastenal info to his email smitho455@att.net, and for him to let me know he got it.
i sent a txt with the address of my nearest Fastenal to his cell 3304954582@vtext.com
sending him a PM on here, ROP, and YB with info again as well
i'll update when he responds
received my parts 08-11... packaged well, on pallet. parts clean and look good at first glance... will update with any issues, or pertinent info after major parts are checked over etc.
thanks smitty! i appreciate everything
thanks smitty! i appreciate everything
last update...
the stock G heads i got from smitty, i had inspected when i got them...
they were pressure tested/checked for cracks
came with all new valves/retainers etc.
smitty had already installed the correct springs for my cam, installed height was 1.900
they had new intake guides
they had new exhaust seats
were cut down for PC seals
came with a good valve job/lapping etc.
all the bolt holes are good
the CC's of the chambers were pretty close to each other, average was 78
all they needed was a 5 thousandths cleanup off the surface
thanks again smitty, i really appreciate it
all done here
the stock G heads i got from smitty, i had inspected when i got them...
they were pressure tested/checked for cracks
came with all new valves/retainers etc.
smitty had already installed the correct springs for my cam, installed height was 1.900
they had new intake guides
they had new exhaust seats
were cut down for PC seals
came with a good valve job/lapping etc.
all the bolt holes are good
the CC's of the chambers were pretty close to each other, average was 78
all they needed was a 5 thousandths cleanup off the surface
thanks again smitty, i really appreciate it
all done here
Last edited by naphtali5725; Oct 17, 2015 at 06:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post



