72 Cutlass Door Panel Molding Question ???
Thread Starter
Registered User
Joined: Sep 2013
Posts: 332
From: 25 miles North of Tampa, Land O' Lakes, Florida (Originally from Bethpage, Long Island, NY)
72 Cutlass Door Panel Molding Question ???
Can someone post a photo of how the lower moldings that separates the carpet from the vinyl go. I'm not sure if it goes to the outside part of the panel or it goes to where the vinyl tab is. Thanks in Advance for any replies.
Just an Olds Guy
Joined: Jul 2008
Posts: 24,528
From: Edmonton, AB. And "I am Can 'eh' jun - eh"
Your door panel is for a 72 Cutlass/Cutlass S. The molding you have appears to be for a Cutlass Supreme
These are the doors on my 72 Cutlass S. Note the difference in trim length?
This is the 72 Cutlass Supreme. Note the higher placement of the carpet and 2 piece trim?
These are the doors on my 72 Cutlass S. Note the difference in trim length?
This is the 72 Cutlass Supreme. Note the higher placement of the carpet and 2 piece trim?
Thread Starter
Registered User
Joined: Sep 2013
Posts: 332
From: 25 miles North of Tampa, Land O' Lakes, Florida (Originally from Bethpage, Long Island, NY)
Thank you Allan, I have a base model 2 dr hardtop. I am trying to clone it into a 442 package. These are the door panels that Legendary said were the proper ones for what I was trying to do. Are you saying that I have the wrong door panels or just the wrong molding?
Thread
Thread Starter
Forum
Replies
Last Post
