Rally-Pac 1975-1977 Olds Cutlass 442
#1
Rally-Pac 1975-1977 Olds Cutlass 442
Good used Rally-Pac gauge for the 1975 thru 1977 Olds Cutlass and 442. The electrical pins are all clean, straight, and tight. The circuit board is fine. $55.00, includes 48 state shipping. Sorry, no pay-pal. PM me if interested.
#2
im interested in the gauges. You have. 405 886 0551 ask for T
#5
Yes I have another one. Email me for details. obryan15@msn.com
#6
Does this plug into the same harness as the regular fuel gauge and dummy lights? Sorry for the "stupid" question, but i would like to have this for my 1975 olds 442, and since it has been about 20 years since I was tearing open dashes on GM's I would like to know I don't have a major rewire ahead of me... Thanks, Chris
#7
If the rallye gauge cluster you got has the connector with the wires cut then you have the order. You can either cut the wires in the dash harness and splice them to the corresponding wires on the rallye connector, or do it the right way and pull the pins out of the original connector and re-arrange them in the correct cavities. You'll need a little pick or paper clip to release the locking tab that holds the pins in the connector.
Starting from the top, here's the wire color/pin location for the cluster:
rallye pac:
dark green
brown
[open]
pink
tan/dbl white stripe
blue/dbl white stripe
tan
[open]
gray
non rallye pac:
gray
drk green
[open]
blue/dbl white stripe
tan
black
pink
brown
tan/dbl white stripe
The black [grnd] wire doesn't go in the rallye pac connector, I added a female spade terminal and attached it to the male spade on the back of the rallye gauge.....IIRC. I'm not the best at explaining things over the computer, hope it makes sense to ya.
Starting from the top, here's the wire color/pin location for the cluster:
rallye pac:
dark green
brown
[open]
pink
tan/dbl white stripe
blue/dbl white stripe
tan
[open]
gray
non rallye pac:
gray
drk green
[open]
blue/dbl white stripe
tan
black
pink
brown
tan/dbl white stripe
The black [grnd] wire doesn't go in the rallye pac connector, I added a female spade terminal and attached it to the male spade on the back of the rallye gauge.....IIRC. I'm not the best at explaining things over the computer, hope it makes sense to ya.
Thread
Thread Starter
Forum
Replies
Last Post