Driveshaft / yoke orientation?
#1
Driveshaft / yoke orientation?
Getting ready to put u-joints in my driveshaft for a '70 442 & was wondering if this is the correct orientation front or back on the driveshaft. I can't remember if the yoke goes on the short or long narrowed end. I've attached a photo to show what I'm talking about. Thanks.
#4
More importantly, when you install the u-joints, be sure the grease fitting holes are in compression when moving forward, not tension.
Thread
Thread Starter
Forum
Replies
Last Post
costpenn
Parts Wanted
2
April 11th, 2012 07:25 PM