Sampson
April 8, 2018
It is tight getting the header into position on this side. I removed the dipstick tube and disconnected the steering shaft at the rag joint to create some room. Removed the starter and jacked the engine up a little. The biggest issue was the Heat shield for the motor mount. This required some fab work. Plenty of room when they are installed and I did not need to bend, dimple or hammer on the headers to make them fit.
More About This Picture
Vehicle
N/A
Location
N/A
Keywords
N/A
Discover More Pictures
See MoreAdvertisement
Be the first to comment on this picture!