Engine / Small Blocks Today 09:52 PM
DJS70cutlass
Ok cool, Amazon will have a couple of them here tomorrow. And if that's the hood you're referring to on the last page of your build thread I have the same one. Was original equipment on the S.
Oldsmobile Parts / Parts For Sale Today 09:45 PM
Nice price Roger
General / The Clubhouse Today 09:38 PM
GCH
Thanks for info Chris , yes it would be nice to have an electric fan to switch on in stopped traffic and slow speed. When we drive cruising here cars can go less 30 mph / and many stops for hours in...
Engine / Small Blocks Today 09:25 PM
If it is the very high temp silver header paint, it will hold up better than most gold paints in that area. Use either Aviation sealant or good RTV on both sides of the cork pan gaskets and RTV in...
Vehicle Lineup / Toronado Today 09:10 PM
Tri-Carb
Perhaps verify 3P again.
jaunty75
AI says 3P is the trunk light.
Koda
This thread is for 1967 Oldsmobile Certification (Cowl) Tag decoding.
Group 1:
0: Two tone paint roof moldings.
E: Tinted Windows (including Windshield)
F: Power Bench
G: Power Tailgate Window...
General / General Discussion Today 09:04 PM
Sleeper!
Go through the chassis & suspension.Box the frame. Box the lower control arms install a sway bar.
Widen the rear steel rims.
9" rear end with locker
Denny's aluminum drive shaft....
Repair & Restoration / Electrical Today 09:04 PM
I’ve researched and I need an 3 prong electronic LED flasher but it’s gonna take the 3 prongs in an unusual alignment. Anybody ever seen one like it. ...
Bet4fun
Thread Starter
Repair & Restoration / Electrical Today 08:45 PM
Does anyone know where I can get a 3 prong turn signal flasher for a 1976 Cutlass 442 since I converted to leds my stock flasher won’t work.
Body & Paint / Paint Today 08:43 PM
I have used Global TCP paint and am satisfied with it.
That was overall refinish though, so I can't speak to matching original paint.
This is the type of paint you car was originally painted...