Oldsmobile Parts / Parts For Sale Today 09:28 AM
Hi,
are you willing to sell the dust caps? I need to find a cap that will fit a 70 delta 88, drivers side with the Speedo recess/setbup. I believe it’s somewhere just over 2inchrs.
would it be...
lmcdevitt
Thread Starter
General / General Discussion Today 09:23 AM
Chris,
it is great to hear from you. I responded to your private note and welcome any help I can get.
I will post about my progress and if/when I locate a good machinist I will post that too.
...
Engine / Small Blocks Today 09:19 AM
An idea...crazy...??? Size the dowel holes in the new plate enough to center the seal on the crank, install the cover loosely, center the seal on the crank and then clamp it in place/position with...
Engine / Big Blocks Today 09:12 AM
GCH
160 lbs , what engine and year is that ? 50 lbs to my -65 425.
rummer
Thread Starter
Oldsmobile Parts / Parts For Sale Today 09:02 AM
1968 Cutlass S hood. Totally rust free. Excellent condition. $1000 USD
1968 Cutlass S front bench seat. Good condition. Recently replaced foam and repaired springs $ 250 USD
Both located in Alberta...
Engine / Small Blocks Today 09:01 AM
I suggest going back to Canadianolds ' comment about fuel pressure. Get a reliable, accurate pressure regulator.:)
New User Forums / The Newbie Forum Today 08:44 AM
Welcome aboard! You're not the first and you won't be the last.
Chassis, Tires/Wheels, Brakes, & Related / Suspension & Handling Today 08:26 AM
When the rubber disintegrates & is lost from a UCA &/or LCA it creates a metal-on-metal (grinding) which can (and will eventually) produce a rounded-out hole where (normally) bushing(s) would seat....
General / General Discussion Today 08:24 AM
This was also an issue when I first went in 1997. I always tried to stay at the host hotel and had several kill switches on my Grand National and fortunately, I never had a problem.