Engine / Small Blocks Today 10:50 AM
Qjet and Holley and Carter/E-brock all use the same diameter air horn. The problem with using a factory Qjet air cleaner on a Holley is clearance to the float bowls, especially with those...
Engine / Small Blocks Today 10:47 AM
Darkrider
My '84 C10 is packing an Olds 350 Rocket. As best as i can tell from the numbers on it appears to be from 1974. It is set up with the Quadrajet and large-cap HEI ignition with gold paint hidden under...
Engine / Big Blocks Today 10:43 AM
While both are at manifold vacuum, I'd run separate ports the way the factory did. The PCV should go to the base of the carb. The booster can be fed from a fitting in one of the runners if there...
Engine / Big Blocks Today 10:42 AM
BillK
Where are you at ? I made this tool years ago when I was working on my Wifes engine still in the car. Bolts to the damper and is long enough to hit the crossmember :)
...
Repair & Restoration / Racing and High Performance Today 10:40 AM
olds70supreme
1. The intake bolt holes barely align w/ the threaded holes in the heads. The bolt is tight to the "bottom" of the through hole in the manifold in order to line up w/ the head. When the head gaskets...
Site Related / Site Suggestions Today 10:36 AM
These newly appearing ads are now on both Safari and my desktop. If I was logged in to CO, ads never appeared until the last couple of weeks.
General / General Discussion Today 10:35 AM
GA heads came from the factory with induction-hardened valve seats, but that hardening layer is so thin that the first time you do a valve job, it all is removed.
General / General Discussion Today 10:31 AM
As I've noted in another thread, got home late last night. Eight days, ten states, 2,900 miles, and several thousand dead bugs. The only problem with the car was that my rear airbags developed a...
General / The Clubhouse Today 10:16 AM
12.54v
Lunch time @ my fav restaurant. Hot & humid, I’m cooked - done for the day.
General / General Discussion Today 10:01 AM
They are externally identical. The only substantive difference is that the 403 uses 1/2" head bolts, so you will need to open up the 7/16" holes in early heads if you are going that way. Of course,...