Ecpirate
Thread Starter
Engine / Big Blocks Today 02:55 PM
Greetings all. My 1967 Olds Delta 88 has a 425 engine. It has hydraulic lifters. My rocker arms have been coming loose after after 30 - 40 minutes of running. They will come off of the push rods....
General / The Clubhouse Today 02:54 PM
Hi everyone.
So I'm out mowing after work today and this big Silverado pickup drives slowly past. I give a half-assed wave and he goes to the end of the street and turns around and sits there. ...
BeenThere
Thread Starter
Oldsmobile Parts / Parts For Sale Today 02:15 PM
https://cimg3.ibsrv.net/gimg/classicoldsmobile.co m-vbulletin/2000x1504/img_1374_a955294b7e4 e57c7fb3b0c6a5dfc2b0 404e8c68a.jpeg...
General / General Discussion Today 01:51 PM
I remember that being an issue with getting junkyard motors. There were so many variations of the 2.2 its ridiculous.
Welp you have the whole truck. I'm sure you're clever enough to swap the...
General / General Discussion Today 01:45 PM
matt69olds
I’m surprised there isn’t more security at the hotels.
It sucks, you can’t go anywhere with your car and really relax and have a good time.
Engine / Small Blocks Today 01:24 PM
OLdGreenPaint
My bohemian solution. I can say that cause I am Czech. I have asked many a store clerk if “No checks allowed” means I can’t come in the store😜
Classifieds / Buyer & Seller Feedback Today 01:24 PM
Thanks Matt!
Repair & Restoration / Electrical Today 01:09 PM
heatmup
This is a no brainer. Progression Ignition small cap. Get a Pertronix Flame Thrower II from Summit. Get a new coil bracket from where ever, they are everywhere. You can even get a female cap and use...
General / General Discussion Today 01:07 PM
Check the spring seats on the two sets of heads. The Ga heads are probably deep spring seats while the C's are probably shallow spring seats. The Ga's probably used valve rotator retainers - hence...
Engine / Big Blocks Today 01:05 PM
Not sure this adds value to what's already being discussed - from my 1971 CSM...
...