Vehicle Lineup / Toronado    Today 11:09 PM

MajD
Norm, I welcome all inputs and information from people that have history and experience with these cars. Thanks for the picture. What I'm talking about doesn't look like that. I haven't had an...
"a thick (10 ga?) wire with a ring terminal runs to a small square unit with a rubber top and metal sides. On top of the unit is a lozenge shaped protrusion that looks like it could house a fuse." A...

Reply
DJS70cutlass's Avatar
DJS70cutlass
Thread Starter

Engine / Small Blocks    Today 09:47 PM

olds 307 and 403
Does your air cleaner look like this?
Yup that's exactly it. Just dug it out of the loft in my garage. Also found two 4 barrel air cleaners that I haven't the faintest idea where I got them. May be able to take parts from all of...

Reply

General / The Clubhouse    Today 09:26 PM

I think purple cap roundup is no longer available. I am using the last of mine and have commercial packaged stuff. I just put down 4 gallons of mix tonight. Ditches, driveway, and around the house. I...

Reply
olds 307 and 403's Avatar
olds 307 and 403
Thread Starter

Engine / Small Blocks    Today 09:12 PM

I finally fixed the fast idle, it was either none or all of it, like 2500 rpm. The cam must have been bent somewhat, looked normal. I had a spare, now1500 rpm on the highest cam and maybe 1300 on the...

Reply
Tirediron's Avatar
Tirediron
Thread Starter

Transmission and Driveline / Transmission    Today 08:54 PM

I pulled the pan and am surprised at how clean everything looks. I put a new filter in it. And new pan and gasket. Next. I'll going to put new front and rear seals....

Reply

Engine / Small Blocks    Today 08:49 PM

Some prefer to use only sealant on the front and rear of the intake leaving out the rubber seals. Probably worth searching this or maybe someone will chime in on what sealant they have recently used...

Reply

Large Oldsmobiles / Eighty-Eight    Today 07:35 PM

I can do that for you. I have a 1964 Dynamic 88. I too am unsure of the actual length, but mine (as I recall) has a notch that kind of locks the cap to the dip stick for proper depth. I'll look...

Reply
davek1661's Avatar
davek1661
Thread Starter

Large Oldsmobiles / Eighty-Eight    Today 07:24 PM

Way back in December- or even November 2025- I picked up a bumper core for my Dynamic 88. It set me back $800 including shipping. I sent it out to a local shop to be chromed, and they found problems...

Reply

Engine / Big Blocks    Today 07:21 PM

Use the pulley reinforcement ring for an Oldsmobile: 1969-72 Oldsmobile Crank Pulley Reinforcement Spacer, Also 1979 Trans Am Olds 403 Engine

Reply

Oldsmobile Cars / Cars For Sale    Today 07:11 PM

oooofdah!!!!!

Reply

All times are GMT -7. The time now is 11:22 PM.