Engine / Small Blocks    Today 01:24 PM

OLdGreenPaint
My bohemian solution. I can say that cause I am Czech. I have asked many a store clerk if “No checks allowed” means I can’t come in the store😜
BTW, your humor did not go unnoticed. :)

Reply

Classifieds / Buyer & Seller Feedback    Today 01:24 PM

Thanks Matt!

Reply

General / The Clubhouse    Today 01:16 PM

Whatever happens tomorrow & the days following will be very interesting, indeed... ...

Reply
matt69olds's Avatar
matt69olds
Thread Starter

General / General Discussion    Today 01:15 PM

Great big steaming piles of horse excrement!! It appears the tone wheel and crank sensors are different between the 97-99 engines. There are other differences, but supposedly that’s the big hang...

Reply

Repair & Restoration / Electrical    Today 01:09 PM

heatmup
This is a no brainer. Progression Ignition small cap. Get a Pertronix Flame Thrower II from Summit. Get a new coil bracket from where ever, they are everywhere. You can even get a female cap and use...
I really don’t like installing unusual critical aftermarket parts on my vehicles. If you have a primitive points style ignition, chances are you can find ignition points somewhere. Same with HEI,...

Reply

General / General Discussion    Today 01:07 PM

Check the spring seats on the two sets of heads. The Ga heads are probably deep spring seats while the C's are probably shallow spring seats. The Ga's probably used valve rotator retainers - hence...

Reply

Engine / Big Blocks    Today 01:05 PM

Not sure this adds value to what's already being discussed - from my 1971 CSM... ...

Reply

General / General Discussion    Today 12:58 PM

I’m surprised there isn’t more security at the hotels. It sucks, you can’t go anywhere with your car and really relax and have a good time.

Reply
67abody's Avatar
67abody
Thread Starter

Oldsmobile Parts / Parts Wanted    Today 12:04 PM

Found my nice survivor Dash pad with Bob aka “65 F85 Cutlass” Thx Bob See feedback section 👍

Reply
Jelonek's Avatar
Jelonek
Thread Starter

General / General Discussion    Today 11:26 AM

Thanks a lot for the great description. I won't be able to check it until next week, though; the machine is running well so far and has good acceleration. Still, there’s always room for improvement,...

Reply

All times are GMT -7. The time now is 01:36 PM.